Separate the firing pin assembly from the bolt body as follows. Then remove the bolt from the rifle and proceed. Swing the safety lever up to the vertical position.

Do you lose the case in the cocking notch? I have your standard heat sink and even made an aluminum one that lasted ONCE. If it isnt, put the bolt back in the rifle and close it. Got it from a old friend who had it for over 50 years. Hensoldt German sniper scope with k98 or Swedish side mount, steel tube. I am looking for a bolt only not a complete or parts rifle. Oxy-fuel maybe shrugs these off where TIG has a pig about it. Hello i am looking for a complete Mauser K98 bent bolt. It ain't fancy but it does the job and doesn't take up a lot of room when I am not using itI'm thinking to coming around to the old oxy-fuel method what with the problems I've had that I think are from ancient oil and grease along with a case that can be here or there in thickness. My Torch is just a Small Port A Torch that they mostly use for doing Air Conditioner repairs and installs. I do sometimes just use Standard gas welding rod and it works fine. 43 Mauser in real good shooting condition No Emails Tex or Phone only. It is a higher nickel content and blues well. 98 Mauser Short Rifle Stock for Large Ring Action, 38' long, Wood As Is. Hello i am looking for a complete Mauser K98 bent bolt.For welding the handles on, I use the same Gas welding touch that I use when I forge over the bolt handles on other bolts.

Mauser k98 bent bolt